• All cabinetry and cabin doors book-matched plain sawn teak veneer in a vertical orientation
• Cabin fronts, drawers, and door backs over Tricel and veneer core Lite plywood panels
• All radius molded plywood corners and curved fronts are veneer wrapped
• Wood countertops throughout vessel in solid teak with minimum seams in wide counter situations
• Flush-front cabinet styling- frameless, transitional look with concealed European style Blum soft close hinges
• Solid teak trim throughout the vessel
• Adequate access panels 
• SouthCo M1 latching lift rings at access 
• Dovetailed , solid Mahogany with 1/2" thick sides mounted on white Accuride side mounted full extension drawer slides
• SouthCo Mobella door handles in polished stainless steel
• SouthCo push button latches throughout in satin brushed nickel
• Recessed LED lights in overhead (Imtra LED with polished satin nickel bezel)
• Whisper wall interior coverings
• Glass panel in door to cabin to provide sun light

• Queen size bed with custom sea rail and 8" mattress
• (1) Drawer under bed to access storage within
• Corian bedside countertops
• (1) Hanging locker cabinet
• "Tile Clad" epoxy painted open storage under bed
• Overhead storage at foot of bed
• Dometic 12,000 BTU A/C unit with Smart Start
• (5) Imtra "Hatteras" LED dome lights
• (2) Bedside reading lights
• Vimar Eikon EVO switches and cover plates
• (2) Vimar Eikon socket outlets
• (1) Vimar Eikon USB charger
• (8) Total drawers

• Teak and Holly hardwood flooring
• Port side galley with custom cabinetry and storage within
• Stainless Steel undermount sink
• Polished satin brushed nickel plumbing and fixtures
• Corian solid surface countertops
• Teak faces on all appliances except mircrowave
• (1) Indel-Webasto Refrigerator
• Built-in GE Convection Microwave Oven

• Stainless steel undermount sink with vanity
• Corian solid surface countertops
• "Wet" head with shower
• Dometic fresh water flush "Deluxe Series" head
• (3) Imtra "Hatteras" LED dome lights
• Vimar Eikon EVO switches and cover plates
• (1) Vimar Eikon socket outlet
• Teak flat panel door with South Co MA McCoy swing door hardware

• High gloss solid teak bridge furniture, aft mezzanine seating with custom tackle center
• High gloss solid teak sliding cabin door
• Bridge AC 16,000 BTU
• Drawer bank in cockpit storage box
• (2) Custom drink boxes in mezzanine
• (1) Custom stainless steel freezer box in port settee
• Primary mechanical space access through bridge deck
• 50 AMP shore power hook-up connections on port side of false transom
• Large insulated baitwell with contoured, rectangular window- acrylic tops bolted in the middle
• Corner transom mounted hawse pipes - $10,000 upgrade
• Under-gunnel LED rope lighting
• Fresh water washdown spigot
• Salt water washdown spigot
• Solid transom swing door
• Garelick swim ladder
• Teak covering boards with 5" round bolster
• Teak decking in cockpit and bridge
• Standard Rupp rod holders
• Swivel HD Rupp Rod Holders
• (6) 7.7 recessed JL Audio speakers
• Release Marine (2) Adjustable bolsters helm chairs with slide assembly
• Release Marine 6-hole rocket launcher with teak drawer
• Three sided acrylic curtain enclosure
• Rod holders for kite fishing at mid ship
• Rod holders in transom gunnel
• Pumps for (2) above deck baitwells
• Wicked Wells bait well for deck with plumbing
• Black Oak Light Bar
• Nite Track Marine Camera
• (2) Custom tackle centers, holds a total of (6) Plano boxes each
• Lumitec underwater lights

• (2) 10" Pull up deck cleats on top deck sides
• (2) 12" Cleats on bow
• Custom removeable bow pulpit and gear
• RC-8 low profile windlass (hydraulic)
• (1) Maxwell polished (Max set 10) 250' anchor rode and chain
• (1) Water fill on side gunnels
• (1) Waste access on gunnels
• Lewmar deck hatch
• Anchor locker with fresh water spigot within
• Non-skid deck with slicks around all hardware
• (6) Standard Rupp Rod Holders
• (2) 7.7 recessed JL Audio speakers
• (4) Electric Reel outlets for electric reels
  • (2) Midship, port and starboard
  • (2) In transom corners, port and starboard
• Bilge access
• Seating at bow for two people

• (2) CAT 7.1 500 HP Engines, 12V
• (2) CAT displays at helm, (1) at tower
• ZF 206-A Marine Transmission
• Glendinning Marine Controls
• Glendinning Marine Joystick System (2 stations)
• Palm Beach levers with bow thruster controls at helm
• Seakeeper 6 Gyro Stabilizer
• Pyrotek insulation
• Side power SE100/185T, 12V, Twin Props Thruster
• (1) Onan 7.5 kW generator 12V
• Sea strainer on Genset
• 12V Jabsco Fresh Water Pump
• 12V Jabsco Salt Water Pump
• 12V Engine Room Lighting
• (1) 12V Sentry Battery Chargers, 60 AMP
• Single 500 Racor Fuel Filter for each engine
• Single 500 Racor Fuel Filter on generator
• (8) Northstar Group 31 AGM Batteries
• 12V Bilge Pumps with High Water Alarms
• Tank sender and sight glass on fuel tank
• Fireboy Halon Fire Control System in mechanical spaces
• Seacocks on all thru hulls
• FRP thru hull fittings above water line
• Dometic KRA 425 Refrigeration System
• (1) Custom stainless steel lined chill box
• Vetus Hot Water Heater, 5-gal
• Fresh water tank, 50-gal
• Dometic Fresh Water Flush Head
• (3) Custom made fuel tanks- (1) Mid ship (approximately 100 Gallons)  and two Rear tanks (approximately 175 Gallons each).  You can transfer fuel from front to back, back to front, and side to side via valves and pumps
• 25 Gal Holding Tank with Macerator Pump and Pump Out Access
• Vetus Grey Water Sump, 15-gal
• All wiring guided by ABYC standards
• 50 AMP 240V, 120V service
• (1) 50 AMP outlet in cockpit
• Whole vessel bonding system
• Custom Paneltronics Panels
• Appropriate wiring to supply systems
• 12V wiring to all systems including navigational lights
• Electrical panel includes: 240V, 120V, and 12V
• (2) Lumishore TIX803 Underwater LED Lights, Blue/White
• Humphree Trim Tabs with Active Ride Control, Single Station
• Von Widmann Underwater Marine Exhaust System

• Bosch Marlin tower w/molded top for 38' Walk Around
• (2) Polished pipe antenna standoffs
• Recessed lights, Lumitec tri color
• Radar pod express style
• Molded one piece standing platform
• Molded 2 in 1 LED spreader light Lumitec light pod aft
• Molded single LED spreader light Lumitec light pod forward
• Control box 63" w/flush mounted compass and side recess access with helm pod
• Painted control box
• Tower sunshade molded top welded antenna mounts
• Custom L-shaped seating
• (6) Polished rod holders welded to rail behind hardtop
• (6) Polished rod holders welded to aft legs
• Rupp outriggers ' double spreader solid back bar with quick release auto lock
• Rupp outriggers mounted on hardtop
• Rupp center rigger
• LED nav port, starboard, stern molded into hardtop
• Recessed lights tri color tower sunshade
• Recessed lights tri color platform
• (2) Refrigerated drink holders

• (2) 22" Garmins at helm 
• 1 Nite Track Camera
• (2) 12" Garmin at the Tower
• Transducer

• Canvas for all furniture and rocket launcher
• Canvas for tower console and tower Seating
• Cockpit canvas with Picnic conversion and poles
• Warranty on CATs until August 2027
• Warranty on SeaKeeper until March 2027 
• Spare parts (Props, several pumps, breakers, filters, hoses)
• Dry Bilge system in engine room, below sea keeper, and in the Lazzarette

Bottom

• (2) Layers 1/2" marine grade Okoume plywood
• (1) Layer 1708 Vectorply biaxial fiberglass outside bottom impregnated with West System epoxy
• (2) Layer 1708 Vectorply biaxial fiberglass on keel and chine
• (1) Layer 1708 Vectorply biaxial fiberglass on keel and chine
• (1) Layer 1808 Vectorply biaxial fiberglass inside bottom up through hull side
• Laminated Douglas-Fir stringers

Hull Sides

• (2) Layers 6mm Okoume plywood, Lloyds type 1088
• (1) Layer 1708 Vectorply biaxial fiberglass impregnated with West System epoxy
• Laminated Douglas-Fir rib bands
• Laminated Douglas-Fir chine
• Laminated Douglas-Fir sheer clamp

Bilge

• All bilges, engine room, and equipment painted in Cloud White

Walk Around Construction

• (1) Layer 1" Diab A500 foam on cabin
• (2) Layers 1808 Vectorply biaxial fiberglass impregnated with West System epoxy

All Exterior Surfaces

• A build up of Alexseal fairing products followed by Alexseal primer to a finished surface
  • Topsides: Cloud White
  • Hull: Light Grey/Kingston Grey
  • Boot Stripe: Miami Blue
  • Bottom: Black

Exterior Finishes

• 1" Solid stainless steel bumper metal

Engine and generator hours are as of the date of the original listing and are a representation of what the listing broker is told by the owner and/or actual reading of the engine hour meters. The broker cannot guarantee the true hours. It is the responsibility of the purchaser and/or his agent to verify engine hours, warranties implied or otherwise and major overhauls as well as all other representations noted on the listing brochure.

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.