Additional 120 gallon fuel capacity

Add 3" to overall height of cabin so OAL headroom is 6'7"

Upgrade to single station hydraulic steering in cabin

Second station hydraulic steering, c/w Attwood steering wheel and dual controls for twin volvos to be installed on starboard bulkhead

Perko four position dual battery switch -- to be installed outside of engine compartment in starboard aft end of rod pocket under coaming

Upgrade bow rails to 30" high

Wood galley package complete with house style sink, faucets, Origo two burner alcohol stove, 20 gallon freshwater tank, 6 gallon grey water holding tank, 3.3 GPM Shurflo pump, & hoses & fittings

Upgrade standard faucets to Moen pull-out faucet

Tundra 4.2 c ft AC/DC refrigerator

Upgrade to Wallas two burner diesel/heater/hotplate plumbed to main tank

Davit, swim arm fold away style, 500 lb capacity c/w hand winch & electric winch

Lockable cabin under second steering station c/w bracket for customer supplied dive compressor

Taylor Made Vector 16 kW heat pump c/w high speed blower -- goes in wet locker c/w touch pad

Walk-thru transom door -- port side

Storage locker in top of transom -- two lids -- full aluminum w/ one drain

Radar arch, 36" high

Compass, Ritchie B-51

Two screens (one each for side sliders, port/starboard)

Screen for Lewmar 13" x 16" hatch in bow

Anchor locker in bow, dual compartment

Heavy duty S.S. "Windline" bow roller, BRM-4 (for Bruce style anchor)

Ray-line 146SL remote controlled spotlight c/w joystick at helm

Deluxe head package: sink with faucets and cabinet, shelves, and two towel bars

Upgrade size of head and wet locker enclosures to 6'7" inside height

Upgrade to Raritan PHII manual head

Plumb hot water to galley sink

Curtains -- double sided, all-around wheelhouse c/w rods

Garelick sport dive ladder c/w three ladder attachments (stern, bow & cabin)

Aluminum 9" x full cabin length shelves c/w curtain rods, one on each side, mounted just below cabin

Aluminum 9" wide shelves in cuddy, one on each side, mounted just below cuddy roof with oak trim

Northern Lights Marine Diesel Generator (#M673L - 6kW @ 1800 RPM) c/w water lift muffler and separator, control panel option #S-1B

Upgrade to full Generator Control Panel option; includes DC voltmeter, water temperature gauge, oil pressure gauge, engine hourmeter, start/stop, and shutdown bypass/preheat switch

High heat sensor/alarm in engine compartment

High water sensor/alarm for engine compartment

Two engine room lights -- Balmar Utility light #458S

Red Dot truck style, 2 speed, 16,000 BTU cabin heater with defrost

Promariner 30 amp - 3 battery charger #61230

Xantrex PROwatt 1750 watt inverter with isolating AC source selector switch

Isolation transformer 3.6 kVA (CMC Electronics) Model number 93-IXFMR3/81A c/w strain relief kit

One Marinco 30 amp plug & 30 amp breaker and two 110V GFI plugs (one in galley, one on port dinette)

Two Trojan 6V batteries c/w battery boxes

Fire stops for vents (port & stbd at cabin bulkhead & port & stbd transom)

Upgrade cabin bilge pump to 1500 GPH with float switch; both float switches to be Attwood non-mercury switches

Upgrade pilot seat to Garelick supersize seat

Garelick seat slider for pilot seat

30 amp Marinco 50 foot dock cord #50PCM

Instatrim tabs 11" x 14" -- comes with rocker switch

Gold Braid 1/2" anchor line -- 300 feet

Lockable storage in cuddy; drop down, masked, 60" x 12" x 12"

Grab bar on roof inside cabin 10" o/c to port side

Sea Dog halogen flood light, 12v 55 watt mounted on aft cabin bulkhead for cockpit lighting

Garelick Heavy Duty S.S. kicker bracket (#71090) mounted on starboard side

Downrigger pads

Downrigger sockets

Modify starboard storage in transom to accomodate kicker fuel tank (5 gallon jerry can included)

Dingy cradle (12' x 5') to be installed on cabin roof

Toe rail along engine hood; fore and aft

Upgrade to fully welded gunwales

Upgrade sump storage access to 18" x 30". To include double cross members

All fills and pump-outs to be located on port side of vessel

Upgrade radar arch to be forward folding/swing away

Upgrade to rear half slider in bulkhead door

Vessel name and port of call decals on transom

Bruce clone claw anchor -- 22 lbs

300' 5/16" anchor chain

• Ventura 150 Watermaker with MPC 3000 display (VT-150-MPC-12) (Trotac) (includes pickling valve & installation)
• Tundra 3.8 cu ft AC/DC freezer (#T38)
• Electro-Guard cathode protection monitor meter -- to be mounted on the port side with probe installed on transom
• Surette 8D battery c/w battery box (upgrade to 2 @ 6V Surrettes line 1014)
• Additional battery switch
• Dual Racor fuel filter (#RAC 7550MAX10) and vacuum gauge (#RACRK11-1669)
• Non-skid deck coat on front deck and 3M grip tape on comings
• Upgrade to lockable engine compartment c/w shocks
• Nicro vent, two speed, 12v, stainless steel -- installed (one in head, one in galley)
• Three additional 110V GFI plugs to be installed -- one in galley, one at main station & one in cuddy
• EDC Monitor for Volvo motors located at second station
• Extention harnesses for above listed EDC monitors
• Battery Isolator
• Upgrade valance for radio installation at main helm
• Additional DC plug-in at main helm
• Additional dome light in cabin
• Port side cuddy bulkhead
• Five tie-downs to be added to outside of transom (two on port side, top and bottom; two on starboard side, top and bottom; one in center, at top)
• Two tie-downs to be added to second station -- on center, one at top of front face, one at bottom of front face
• Adjust anchor holder for customer supplied "Hooker" anchor
• Two stern handles to be welded on to back of transom at gunwale for boarding from swim grid (one port, one starboard)
• Toe-stop to be added to swim grid as per customer specifications
• Drawing/template of dash and any ducting/wiring
• Hold down for the microwave
• Install customer supplied depth sounder c/w two transducers
• Chart plotter sending unit to be mounted below roof hand rail to facilitate removal upon storage c/w stainless steel mount
• Customer supplied GPS to be installed on dash
• Installation charge for customer supplied hailer -- includes 2nd customer supplied mike
• AC panel to accomodate customer identified electrical requests
• Basic sketch of all electrical in the boat
• Hold down for batteries (standard web & plywood)
• Hand rail located on dash above cuddy entrance -- powder coated and installed
• Increase davit reach by 12"
• Rod holders to be added at locations specified
• Additional downrigger pad beside transom door for pot puller
• Upgrade dinghy cradle to support full bottom of dinghy -- including center balance point and four additional balance points
• Tee shaped boat hoist c/w swing mechanism to be added to davit
• Radar box for radar storage -- 3/16" lid
• Coaming rails -- 24" long, 10" tall
• Additional pad eyes -- one on bow and two on transom for moving boat with come-along
• Blower for head ventilation -- includes installation
• Upgrade radar arch to be forward folding c/w heavy duty hinge
• Install customer supplied autopilot system
• Foot switch installed at bow for Maxwell Freedom windlass
• Outrigger sockets
  

• Upgrade to full Generator Control Panel option; includes DC voltmeter, water temperature gauge, oil pressure gauge, engine hourmeter, start/stop, and shutdown bypass/preheat switch
• Exchange Norcold refrigerator for Tundra 4.2 cu ft AC/DC refrigerator (#T42)
• 30' hose coil hose
• Two Trojan 6V batteries c/w battery boxes
• Dual Racor fuel filter (#RAC 75500MAX10) and vacuum gauge (#RACRK11-1669)
• Windlass switch 
• 300' 5/16" anchor chain
• Curtains -- double sided, all-around wheelhouse c/w rods
• Drop curtain at entrance to cuddy berth
• 30 amp Marinco 50 foot dock cord #50PCM
• Gold Braid 1/2" anchor line -- 300 feet
• Nicro vent, two speed, 12v, stainless steel -- installed (one in head, one in galley)
• Command Mic for customer supplied Icom 127 VHF (ICOM HM-127B)
• Two 6" x 10" skeg deflectors
• Foot switch installed at bow for Maxwell Freedom windlass
• Perko four position dual battery switch -- to be installed outside of engine compartment in starboard aft end of rod pocket under coaming
• Additional battery switch

The Company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change, or withdrawal without notice.